Next, the water seal, lock ring and other parts need to be installed.　　Causes: there is air or gas accumulation in the water inlet pipe of the pump, or the bottom valve is not closed tightly, the water supply is not satisfied, the packing of the vacuum pump leaks seriously, and the gate valve or flap valve is not closed tightly.El palaiso,　　Consider the vertical separation level of the tail equipment. The water pump control cabinet has a variety of protection s and complete status display,El palaisoSmall deep well pump, such as overload, phase loss protection, pump body water leakage, motor over temperature and electric leakage, as well as single pump and multi pump control working modes,El palaisoSubmersible non clogging slurry pump, a variety of main and standby pump switching modes and various　　It, generator and market formed at the beginning of construction have gradually formed a certain scale after more than ten years of rapid development. In the early stage, in order to meet the needs of market development, generators and other mechanical and electrical products were collectively moved to the phase II market for operation. With a good business environment, water pumps and generatorsGeorge-Town,　　Its main features are as follows: the whole machine is a dry-type motor pump structure. The motor is protected by mechanical seal, which can effectively prevent high-pressure water and impurities from entering the motor cavity. In addition to the main impeller, it is also equipped with a mixing impeller, which can pump out the slag settled at the bottom after stirring into turbulence. impeller　　Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.　　Is called cavitation phenomenon.

　　Is called cavitation phenomenon.　　The self-priming pump is a self-priming centrifugal pump. It has the advantages of compact structure, convenient operation, stable operation, easy maintenance high efficiency, long service life, it is only necessary to ensure that a certain amount of liquid is stored in the pump. Different liquids can　　Screw it down, and then remove the bearing inner race O-ring, shaft sleeve and retaining sleeve in turn.Interpretation and observation,　　Basically,El palaisoRubber lining submerged slurry pump, the reasons for the motor heating of the submersible slurry pump are the above items. If the motor heating occurs, you can find the reasons from the above items. However, it must be noted that if the fault is caused by electricity, people who do not know electricity should not repair it by themselves, so as to avoid people　　The development of submersible slurry pump is to adapt to increasingly complex working conditions, facilitate users to use, that is, in the traditional slurry pump　　The impeller of the submersible slurry pump may need to be disassembled for maintenance or repair during use. However, when we do not know the pump structure, we may make mistakes during disassembly. Let&#;s take a look at the correct disassembly of the impeller

　　If the water leakage is serious, the broken pipe shall be dismantled and replaced. Lower the lift and press the nozzle of the water pump into the water for .m.Energy costs,　　Pressure. Therefore a pressure gauge should be installed in this system to monitor whether the pressure meets the requirements.　　The course can be stronger.　　 the water pipe shall be short, and the cavitation allowance of the device shall be greater than that of the pump. It is recommended to use the reverse charging installation method when transporting residues with high weight concentration.El palaiso,　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.　　Work, no noise and vibration, and the site is cleaner.　　How to disassemble the submersible slurry pump and how to assemble it after disassembly. The technical points and precautions for disassembly will be introduced to avoid disassembly, pump damage and disassembly.