and its attachment distance

The wall bracket of the construction electric elevator should be intact and reliably fixed, wall bracket spacing,DongzhouDalas, and end height must comply with the requirements of the 'User Manual'. The angle between the plane of the wall bracket and the normal direction of the attachment surface should not exceed degrees;. When the attachment device does not meet the requirements of the 'User Manual' due to conditions,DongzhouAuckland, its calculation sheet, design, and production materials should be confirmed by the manufacturer or reviewed by the technical leader of the installation unit, and verified by experts.The full height landing door should meet the following requirements: the net height of the landing door opening should not be less than m. In special circumstances, when the net height of the building entrance is less than m,DongzhouBisegli, it is allowed to lower the height of the lower door opening but in any case, the net height of the lower door opening is not less than m. (Article of GB-)Dongzhou,Do not move after lifting, and do not lift until the four legs are firmly supported.The safety notice board for construction electric elevators should be prominently placed on the hanging cage for the rated load capacity and rated number of passengers of the construction electric elevator. It is strictly prohibited to use construction electric elevators beyond the rated load capacity or rated number of passengers.Antalaha,The foundation base or embedded parts should be fully embedded in the concrete foundation plate.When the wall bracket cannot meet the requirements of the construction site, civil engineering, and operating costs. The editor of the electric elevator will provide a detailed analysis: the advantages of the product are that the equipment bears a large load, can achieve multiple points, and can be controlled up and down floors to achieve safe use.

The oil cylinder and sealing components are made of imported components to solve the problem of unstable oil pressure and oil leakage of components for customers.When using lifting equipment, the workbench should be kept in a horizontal state.The setting of the cable guide frame should comply with the user manual and regulatory requirements.Create brilliance,Setting requirements: Each landing entrance should be equipped with a landing door, which should cover the opening with its full width, those that have undergone national safety certification will not have significant safety issues. The main problem is that after using the electric elevator for a period of time, mechanical components may fall off or be damaged due to various factors. This problem depends on regular inspection and maintenance of the machinery

Drainage measures need to be considered around the foundation. (Drain the accumulated water on the foundation).Service first,Implementing multiple shifts of homework should fill in and submit records according to regulations.It is strictly prohibited to use travel limit switches as switches to stop operation.Setting requirements: For construction electric elevators that operate in multiple shifts the handover system should be implemented, and drivers should fill out the handover record form according to the standard requirements. The driver should conduct a pre shift inspection and confirm that there are no errors before starting the machine for operation.Dongzhou,When applying a normal force of N to any position on either side of the door using a rigid mm square or circular flat surface in the locked position of the landing door, the door should be able to withstand and have no deformation; - Deformation not exceeding mm; After the test, it worked normally.From the above comparison, it can be seen that hydraulic electric lifting mechanisms have stable lifting, low noise, long service life, large load bearing capacity, and are relatively simple, making them suitable for use in stage equipment.Before installation, the installation unit should confirm that the foundation, foundation bearing capacity, embedded parts, and foundation drainage measures of the installed construction electric elevator and auxiliary heavy equipment comply with the requirements of the special construction plan for the installation and dismantling of the construction electric elevator based on the construction electric elevator foundation acceptance form, concealed engineering acceptance form, and concrete strength report.