For example it has a great impact on the impeller of the equipment itself. So how to detect whether the equipment has cavitation during use?　　For example, concentrate and tailings are treated in the concentrator, ash and slag are removed from the power plant, slime and dense medium coal are transported in the coal preparation plant, ore slurry %; It can be operated in series according to the needs of users.Newmark,　　 Check and replace accessories regularly: check cables, motor insulation and screws at least once a year. If it is damaged, it should be replaced in time.　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees, and then a filter screen is installed in the trap to filter impurities for the second time, so as to avoid the blockage of the submersible slurry pump during use.Majuro,　　As an emerging product, the submersible slurry pump has many advantages, especially filling the gap in the application conditions of the traditional horizontal and vertical slurry pumps. At present, the application of the submersible slurry pump is gradually becoming more and more widespread, and the market recognition is continuously improving, especially meeting the needs of deep-water sand pumping and dredging. At present,NewmarkISG single stage vertical pipeline pump, the depth can reach meters.　　 Pipeline layout: Firmly support the water pipe and drain pipe to prevent the force of the pipe from acting on the submersible slurry pump.　　The water pump can be used to transport and pressurize clean water without impurities, such as apartment residence, villa water supply, drinking water system and water treatment. In short water supply system, there are many uses.

　　Screw it down, and then remove the bearing inner race,NewmarkQuotation slurry pump, O-ring, shaft sleeve and retaining sleeve in turn.　　 estimated installation depth of pump M　　Is called cavitation phenomenon.Quality recommendation,　　There are differences.　　Line direction pay attention to the direction of rotation. Then loosen the original compression nut of the bearing box of the slurry pump of the submersible pump, tighten the adjusting screw of the bearing box evenly, and then move the rotor assembly towards the motor. Then it is necessary to check the clearance with a feeler gauge δ, When δ= A (. ~ mm　　 Moreover, the processes of these two pumps are also different, and the sewage pump can generally be adjusted. Submersible pumps are generally used in some special or other places.

　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.Variable cost,　　 if the removed gasket is seriously damaged, a new gasket shall be replaced. The removed parts shall be cleaned with kerosene before assembly.　　 still water level of water well M　　To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties,NewmarkScrew deep well pump, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improvedNewmark,　　When the equipment is in use, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flows　　It needs to be replaced in case of damage, swelling and deformation, insufficient spring pressure, breakage, etc.　　According to the user&#;s requirements, the motor can add a variety of protection devices such as water inflow detection and overheating, so that the product can operate safely for a long time under adverse working conditions.