The household must make two steel splints above the entrance. The position and size of the clamp plate are determined based on the selected door machine model.Machine room power supply: The power supply should be three-phase V, HZ, and the lighting power supply should be single-phase V, HZ. The incoming line should be connected to the vicinity of the machine room entrance and equipped with an incoming socket. Specializing in product and renewable resource business, including: home elevator manufacturersAfragola,These phenomena are not elevator malfunctions. When the elevator is fully loaded the elevator does not stop: to avoid overloading, the elevator car no longer responds to the next station's outbound call.The compensation chain and rope shall not collide with the shaft or other components during the operation of the elevator.Warin Chamrap,Brick concrete structure elevator shaft: For unfinished brick structure shafts, users can be required to make a circle of beams at a certain height, arranged on three sides, and should not exceed mm. The beam height should be mm, and the thickness should be the same as the wall. The lower ring beam is -mm away from the bottom of the pit,AfragolaHydraulic fully automatic plate rolling machine, and the higher ring beam is -mm away from the lower surface of the shaft roof. The completed framework with a solid brick structure shaft can be equipped with steel plywood at the position of the fixed guide rail support frame. The position and size of the plywood are provided by the elevator, and the user is responsible for providing materials and construction. If the shaft structure is made of hollow bricks without ring beams, steel beams can be considered to be added between the frames for rectification.When the normal power supply is cut off, the lighting inside the non fire elevator has no power, its safety cannot be guaranteed. If the elevator needs to be refueled without refueling, it will cause wear and tear on the mechanical components of the elevator, greatly shortening its service life and preventing normal use of the elevator.

The compensation chain and rope shall not collide with the shaft or other components during the operation of the elevator.Aircraft weighing tens or hundreds of tons in the elevator hangar are vertically lifted onto the airport runwayMeasure the beam edge distance between the upper and lower support beams. The measurement is to suspend the line from the upper support point to the ground for positioning, and then measure the horizontal distance from the positioning point to the edge of the lower support beam.Service first,Measurement of elevator and escalator shafts (III)The front room of the fire elevator is equipped with indoor fire hydrants.The requirement for the shaft is that it should not be plastered, but there should be no protruding foreign objects.

The call button on each floor is no longer working, and the call is cut off.Administration,If the elevator is already on the first floor, immediately open the elevator door and enter the firefighter's dedicated state.Elevator Tip : Why elevators can trap people? Every elevator door on each floor has a safety switch, which can trigger the elevator to shut down in case of any abnormality. The elevator getting stuck is actually when the system detects an abnormal signal and triggers a protective device,AfragolaHydraulic flipper manufacturer, like braking to stop.Attention: The elevator consists of two main parts: mechanical and electrical. If the elevator is not maintained on a daily basis, its safety cannot be guaranteed. If the elevator needs to be refueled without refueling, it will cause wear and tear on the mechanical components of the elevator, greatly shortening its service life and preventing normal use of the elevator.Afragola,Please note that there should be a space of over mm left on both sides of the escalator and when arranged in parallel, there is no restriction between the two escalators.For escalators that require intermediate support, it is necessary to determine whether the site has the conditions for adding support,AfragolaFully automatic hydraulic tipping machine hopper, as well as the range of support that can be added, the height and load size of the equipment and support platform, and other parameters.Measurement of elevator and escalator shafts (III)