Metal oxide arresterRefrigeration equipment for medical cold storageBasic principle of production processing surface

2022-08-15 03:59:23
632HP195506591energy266

The lights in the warehouse are not on. Please check whether the switch fails and whether the bulb is damaged. Cut off the power supply when installing the lampshade and pay attention to the waterproof of the lamp.Acid disinfectant can be used for mold removal and disinfection of quick-frozen warehouse.Metal oxide arrester,Degree, suction temperature, motor temperature, crankcase temperature and temperature in front of the valve, observe the frosting of the evaporator and valve, and observe the oil level and color change of the oil mirror. Whether the sound of equipment operation is abnormal.When installing the polyurethane insulation board, the adhesion between the panel of the polyurethane insulation board and the thermal insulation material is short and often high.Ciudad-Juarez,First, use a hammer to pad the wood on the polyurethane warehouse board between the two warehouse boards, so as to make the boards closely close to each other. Two sets of connecting pieces shall be wedged between the wall panel and the wall panel, and the two sets of connecting pieces shall be fixed on the upper, outer and lower sides of the gap between the wall panel and the wall panel respectively. The lower connecting piece shall be as close as possible to the lower side, so that the post cast concrete can cover the connecting piece. After the gap between the plate and the plate ground is wedged with a connector, it shall be about mm wide. If it does not meet the requirements, remove the plate, trim the plate edge, and then reinstall it to make the plate joint meet the requirements. When fixing the adapter, pay attention to fix the two parts of the adapter on the edges of the convex and concave library plates respectively, and fix them with rivets. The spacing of the adapter should be able to tension the two library plates. When wedging the wedge iron, the hammer shall be perpendicular to the wedge iron to prevent damaging the warehouse plate. The ground wedge iron at the upper and lower parts shall be wedged at the same time, and the wedge iron shall be fixed with rivets.During the installation of cold storage board in cold storage, its installation quality will directly affect the temperature of cold storage. As an important structure used in the cold storage, the cold storage board should pay attention to the details of its installation, find out the problems that are easy to be ignored, and avoid the wrong installation which will affect the use of the cold storage or the whole installation process, in the face of the above possible situations so as to waste resources and increase the cost.The use of large-scale cold storage is naturally very strict in installation and material selection. Therefore, we can strictly screen the insulation board materials of cold storage, which can effectively alleviate or solve the above problems. However, at present, there are many fields using cold storage insulation board, so the details of the use environment should be considered for the wood making of many such products in the market.


Metal oxide arresterRefrigeration equipment for medical cold storageBasic principle of production processing surface



The equipment configuration is reasonable and the service life of the quick freezing warehouse is long. The reasonable equipment configuration of the quick freezing warehouse can greatly prolong the service time of the quick freezing warehouse. Some compressors are easy to be damaged when they work at full load for a long time,Metal oxide arresterPharmaceutical warehouse management system, so we try to use screw parallel units. The great advantage of this unit is that it can turn on all equipment, just like the shift at work, and the condenser shall be cleaned and masonry removed regularly to ensure the normal and stable operation of the unit.The temperature and humidity in the warehouse shall be kept uniform without movement; Try to finish the food in the warehouse at one time.offer,Where do you need to build the refrigerator,Metal oxide arresterCold storage production and installation company, the size of the refrigerator or the storage capacity (size, storage capacity, ton, cubic meter, frame, box); What products are stored in the built cold storage? The actual storage temperature, storage time and setting temperature can be indicated by specific regulations; If your cold storage becomes larger,Metal oxide arresterHow much is the general cold storage installation, you need to master your individual storage volume, the temperature of goods in and out of the warehouse, the frequency of opening and closing the door, etc. If this is clear, it is the selection of raw materials, refrigeration units, industrial cooling fans / pipe slots, thermal insulation materials, coolers, doors, temperatures and other refrigeration equipment.When opening and drilling is required for the top warehouse plate or wall plate, and the opening and drilling shall be carried out after review; The inlet hole, liquid inlet hole return hole, and the orifice shall be closed with foaming material or sealant to prevent air leakage and cold running; The door, vent and delivery port shall be decorated with wrapped edges and fixed with pull rivets, with a spacing of mm and mm outside.Acid disinfectant can be used for mold removal and disinfection of quick-frozen warehouse.


Metal oxide arresterRefrigeration equipment for medical cold storageBasic principle of production processing surface



Suggestions on the quantity of polyurethane cold storage insulation materials: cold storage investment is a long-term and profitable investment. A high quantity of hair can certainly reduce the initial investment, but it is necessary to grasp a certain limit and comprehensively consider the long-term energy consumption and initial investment, because the insulation effect of polyurethane cold storage insulation materials has a parabolic linear correlation with its bulk weight; A large number of studies have shown that the foam bulk density has better thermal insulation performance at ~ kg / cubic meter. Therefore, it is usually recommended that the number of thermostat refrigeratory outlets should be ~ square / ton.Trustworthy,Watertight polyurethane rigid foam has low water absorption, good permeability to water vapor, and state of foam pores. It is not connected with each other, and the obturator rate is more than %. It is a dense microporous foam material, which is more dense than the surface of the air, and is not easy to permeate. It is an hydrophobic material.The air in the controlled atmosphere storage shall have appropriate circulating stream to make the air temperature in the storage uniform. If the circulation stream is not carried out, the air in the warehouse absorbs the respiratory heat of vegetables and the heat leakage of various parts, which increases the upper temperature and is easy to deteriorate the products. Especially soon after vegetables are put into storage, it is more necessary to strengthen ventilation and circulation.Able to withstand the harsh local climate and its changes. Neither high temperature nor severe cold climate will cause irreversible damage or deformation to the external insulation system. The drastic change of the surface temperature of the external wall, such as the sudden shower after a long time of exposure, or shading during exposure, the wall panel joints shall be evenly sealed and decorated with silicone sealant.Watertight polyurethane rigid foam has low water absorptionThe spacing of pull rivets at inner and outer corners is mm and mm respectively; After the polystyrene library is installed, good permeability to water vapor, and state of foam pores. It is not connected with each other, and the obturator rate is more than %. It is a dense microporous foam material, which is more dense than the surface of the air, and is not easy to permeate. It is an hydrophobic material.The refrigerant charge is insufficient. At this time, just add enough refrigerant.

404 Not Found

404 Not Found


nginx

Related articles

Metal oxide arresterRefrigeration equipment for medical cold storageAnalysis of the working principle of

Metal oxide arresterRefrigeration equipment for medical cold storageAnalysis of the working principle of

the machine stops running under the action of the pressure controller. When the heat dissipation is...

评论列表

35HP162657470
2022-08-15 11:32:49

I heard a colleague's introduction to buy Metal oxide arresterRefrigeration equipment for medical cold storage, and they all said that the quality is good, and I will come to your house next time. Ha ha.

570HP155642700
2022-08-15 11:47:19

I have almost never seriously evaluated it before. I bought yours Metal oxide arresterRefrigeration equipment for medical cold storage and will visit it next time. It is so convenient that I can’t stop at all. It’s a genuine product with fast logistics. I like it for you.

709HP180518493
2022-08-15 12:59:19

Feels of value for money, service attitude is very good, Metal oxide arresterRefrigeration equipment for medical cold storage workmanship is very good, nothing fussy, all five points

发表评论    

◎欢迎参与讨论,请在这里发表您的看法、交流您的观点。