Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.High lifting height, using side mounted oil cylinders, stable operation, noise free, easy maintenance, it should be scrapped.Small safe operation distance: Circuit voltage (kV) of external power lines<~~~ Small safe operation distance (m) Setting requirements: A small safe distance should be maintained between the outer edge of the construction electric elevator and the edge of the external overhead power line.Dajabon,Especially suitable for steel structured factories, suitable for both indoor and outdoor installation.In addition to ground protective fences, low level doors can be used. Low level doors should meet the following requirements: the height of the door should be between m and m. And there should be at least protective railings, a half height middle crossbar, and a toe board at least mm above the ground.The entrance of each landing platform must be equipped with a landing door, which must open towards the landing platform side and the door bolt must be set on the side next to the construction electric elevator.

Flat screw mechanical electric lifting mechanism: The lifting platform of this structure has the advantages of small civil engineering coordination, shallow foundation pit required, large stroke, stable operation, low noise, accurate positioning, and low cost. Adopting a horizontal screw drive and a scissor fork structure to achieve the lifting motion of the table, it can be stopped arbitrarily within the range of travel.How to determine the sufficient amount of clean oil for the hydraulic station of an electric elevator? Why cannot water be used to flush the hydraulic station of an electric elevator?Pipeline rupture valve: When the hydraulic system pipeline ruptures and the car stalls and descends, it can automatically cut off the oil circuit and stop descentQuality documents,Setting requirements: The layout and installation of all cables and wiring of electric elevators should be able to prevent mechanical damage.Setting requirements: The installation and dismantling workers, electricians, and other operators of construction electric elevators should have special construction operations.Setting requirements: The foundation and foundation of the construction electric elevator should meet the requirements of the user manual. Before installing the construction electric elevator, the foundation should be inspected and accepted according to the requirements of the specifications. Only after passing the inspection can the installation be carried out.

The foundation base or embedded parts should be fully embedded in the concrete foundation plate.Information recommendationInstallation and dismantling personnel and drivers should hold certificates to work.Do not move after lifting, and do not lift until the four legs are firmly supported.During normal operation, the horizontal distance between the closed cage door and the closed landing door should not exceed mm. Otherwise, measures should be taken to make it meet the requirements,SolnockXing'an League, or side protection devices at the entrance of the landing station that meet the requirements should be equipped. The distance between any opening between the side protection device and the hanging cage or landing door should not exceed mm.Solnock,The scaffolding of the parking platform should be laid tightly and firmly.Steel wire ropes, pulleys, and counterweight steel wire ropes shall comply with the following regulations: the characteristics of steel wire ropes shall comply with the requirements of General Purpose Steel Wire Ropes GB/T; Maintenance, wear,SolnockBrasilia, deformation, and corrosion of steel wire ropesDouble layer steel mesh: The diameter of the steel bars is mm, with a spacing of mm.