screw down the bolts on the side bearing pressure cap, and then remove the nuts used for the connection between the three parts: discharge section, stuffing box body and bearing body; Then screw off the round nut on the shaft, and successively install the bearing inner race, bearing gland and retaining sleevePepper,　　At this time, it is necessary to use the fire control cabinet. The fire control cabinet can control multiple water pumps to ensure the normal operation of the fire pumps.　　 To ensure the efficient operation of the submerged slurry pump, the clearance between the impeller and the front guard plate must be adjusted regularly to keep it between (.-mm). In addition to monitoring the flow and pressure during the operation of the pump, the motor shall not exceed the rated current of the motor. Monitor oil seal and bearing at any timeKandi,　　 When the slurry pump fails to absorb water during operation it may also be because the bottom valve is not opened. At this time,PepperSewage pump diving, it is necessary to check whether the bottom valve is open and make corresponding adjustment.　　When the water level reaches,PepperLong shaft submerged slurry pump, the frequency of the frequency converter drops, and the slurry pump operates at a low speed. The higher the water level, the lower the speed; The lower the water level, the higher the speed. At the same time, the water level signal is transmitted to the control cabinet so that the operators can timely understand the liquid level. Through this control, the circulation in the slag slurry pool is basically unchanged　　The above four methods can be used to detect whether the submersible slurry pump has cavitation, because if the equipment is in use, it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump

　　In fact, it can only be opened or closed, the stator winding will be burnt out due to excessive temperature rise.wholesaler,　　In fact, it can only be opened or closed, and the action time when opening and closing is relatively short.　　The above four methods can be used to detect whether the submersible slurry pump has cavitation, because if the equipment is in use it will have a great impact on the operating efficiency. Even if the cavitation time is long, it will also have a certain impact on other parts of the equipment. Sometimes submersible slurry pump　　 repair and level the welding part of the submersible slurry pump with a file, clean the part to be bound with alcohol again and wipe it dry.

　　Only in this way can its service life be extended to a large extent.Design brand,　　Water pump After understanding the cause of insufficient liquid supply, we can solve the problem: First, we need to check whether the liquid level of the circulating liquid storage tank needs to add media to it.　　The water pump is not installed firmly or installed too high.　　Occurrence of personal injury accident. The slurry pump is mainly used to transport water or similar media when in use. It can also be regarded as a common pump in our life, but it will also be overloaded when in use. Let&#;s have a look todayPepper,　　When the submersible slurry pump is used at ordinary times cavitation usually occurs, which has a great impact on the impeller of the equipment itself. So how to detect whether there is cavitation when using the equipment at ordinary times?　　The use of water pumps is related to all aspects of our life. With the arrival of the May Day holiday, the water consumption will increase. Therefore,PepperVertical centrifugal slurry pump, it is necessary for us to choose a suitable water pump.　　First, the reason for the motor body: the wrong connection will make the temperature rise rapidly when the equipment is used; In addition, there may be some phase to phase short circuits between stator windings, so when the situation is relatively minor, the motor is only in local places