Therefore, the stator winding will be burnt out due to excessive temperature rise.　　 After each use of the equipment high-pressure water should be used to wash the pump and pipes. The washing can be stopped until the water has no impurities.Matamoros,　　Attachment: data sheet required for ordering deep well pump　　The slurry pump of underground pump can also work normally.Kungsbacka,　　It is longer and saves production cost. The whole industrial and mining system operates stably and will not affect the work of the whole industrial and mining system due to the operation of the pump. When the rotating speed of the submersible slurry pump cannot be changed and the lift is higher than the required equipment lift, the cut impeller is usually used. The cut is　　In addition to the main impeller inside the equipment, a set of impeller for mixing will be added at the bottom of the equipment,MatamorosSingle stage slurry pump, so that the equipment can be used without its　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.

　　 When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time it is necessary to check whether the bottom valve is open and make corresponding adjustment.　　 Professional maintenance: if the submersible sewage pump cannot work normally, do not disassemble and repair it without authorization, but carry out professional maintenance immediately.　　The purpose is to inject liquid higher than . MPa from the water seal ring to prevent gas leakage into the pump when the suction inlet of the submersible slurry pump is in a vacuum state. When the water pressure in the pump is higher than . MPa, the sealing fluid .-. MPa higher than the pressure in the pump can be injected to seal and reduce leakageHonest management,　　The impeller of the submersible slurry pump may need to be disassembled for maintenance or repair during use. However, when we do not know the pump structure, we may make mistakes during disassembly. Let&#;s take a look at the correct disassembly of the impeller　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.　　 for screws that are too tight or rusted for a long time,MatamorosWear resistant slurry pump, the nut can be lubricated with kerosene prepared in advance, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.

　　Through the introduction, we learned that the submersible slurry pump can be used to transport slurry when it is used at ordinary times. The relationship between its special structure is very close, but in fact, it also needs to be used in a correct way when it is used at ordinary times. Only in this way canTrustworthy, the sealing fluid .-. MPa higher than the pressure in the pump can be injected to seal and reduce leakage　　The answer to this question must be! Submersible sewage pump has attracted more and more attention because of its wide range of applications and strong sewage treatment capacity, but improper use and maintenance will lead to submersible sewage.　　The premise of using this method is that the water gun must have sufficient flow during use, otherwise the effect of the submersible slurry pump may not be obvious.Matamoros,MatamorosWQ submersible sewage pump,　　It should be /-/ between. When the packing is worn, the packing gland can be properly pressed. If it is worn too much, it should be replaced. The whole commissioning process of the submersible slurry pump mainly includes the above five tasks, which are mainly to pay attention to the details and the phenomena occurred during the operation, and timely deal with the problems in time to avoid being on duty Accidents during operation cause losses.　　All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.　　The other mechanical seal is a split seal, which can be replaced without disassembling the slurry pump.