LavenderPipeline pumpHow to eliminate the oscillation problem
2024-04-09 00:15:21Different installation requirements: the vertical slurry pump needs to be fixed, while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation. Only in this way can its service life be extended to a large extent.Lavender, before starting, check all circuits and switches to see if their wiring is correct and reliable, then turn them over the ground for ~ minutes (the time should not be too long to avoid damaging parts or burning motor windings),LavenderDrilling fluid slurry pump, and check whether the motor running direction is correct. If the above problems are not found, it can be started The pump can often be selected according to the specific requirements of lift, flow and liquid delivery. The flow range of the delivered liquid is - L / s, the pressure range is .- MPa, high automation and performancePyongyang, Third, the whole industrial and mining system operates stably and the operation of the pump will not affect the work of the whole industrial and mining system. It is also necessary to clean the ventilation duct to avoid blockage. If there is no corresponding water leakage sensor,LavenderSubmersible sewage pump, it is necessary to regularly maintain the submersible slurry pump and replace the seals.
There will be no insufficient liquid supply or other problems. Lifting, loading and unloading of electric pump: remove the cable and disconnect the power supply. The above is the correct sequence of impeller disassembly of submersible slurry pump. Because different types of pumps have some differences in structure, we also need to refer to the instructions when disassembling.Information recommendation, With water, you can start working. A large amount of lubricating oil is stored. The rotor assembly is designed according to the actual situation and the operation is more stable!
In fact, it can only be opened or closed, and the action time when opening and closing is relatively short.how much, Inspection before installation: Check the specification,LavenderSewage pump diving, size and quality of thick and thin accessories. Stop the operation immediately under any of the following conditions: the current exceeds the rated value at the rated voltage; Under the rated head, the flow rate is much lower than that under normal conditions; Insulation resistance is lower than . megohm; When the dynamic water level drops to the pump suction; When the electrical equipment and circuit are out of specification ; In practical application, the submersible slurry pump is developing rapidly with its unique advantages. The vertical slurry pump needs to be fixed and installed in use, while the submersible slurry pump can be used directly without immersion, which is convenient and flexible.Lavender, Different installation requirements: the vertical slurry pump needs to be fixed, while the submersible slurry pump does not need to be fixed. It can directly invade into the liquid for operation. When the slurry pump fails to absorb water during operation, it may also be because the bottom valve is not opened. At this time, apply a layer of lubricating oil on the mounting surface to protect the shaft hole from damage.