Different process requirements: the motor used in the vertical slurry pump is an ordinary vertical motor, which has no waterproof . The motor of the submersible slurry pump and the pump shaft are coaxial. The motor shall be waterproof and sealed. The motor and the pump body can invade underwater at the same time.　　Stability and reliability of seals between pump bodies.Chakarita　　Operation, maintenance and upkeep During the operation of the electric pump, voltmeter and water flow, and strive to make the electric pump operate under the rated working condition.　　The above introduction is about the cause ysis of the overload of the slurry pump. When we find these conditions when using the pump, we can check whether these reasons are the above. This is also a reminder that we need to maintain the pump during normal use. latentCyprus,　　After that, the secondary and tertiary pumps can be started successively until the final stage pump. After all the series pumps are started, the outlet valve of the final stage pump can be gradually opened. The speed of opening the valve should be controlled by the fact that the pump does not vibrate and the motor of any stage does not exceed the rated current.　　There will be no insufficient liquid supply or other problems.　　Potential energy, pumping water up high. However, once the pump can not absorb water, the equipment is shaped like a decoration, so what is the reason for this situation? How to solve it?

　　Third, the whole industrial and mining system operates stably, and the operation of the pump will not affect the work of the whole industrial and mining system.　　 Long continuous operation time. Because the pump and motor are coaxial, the shaft is short, and the service life of the submersible sewage pump is much longer than that of the general pump.　　 It may be that the motor power of the water pump is too large the radial load on the bearing is relatively small, the working current is too large, and the heat generation is too large,ChakaritaSelf priming slurry pump wholesale, resulting in the high temperature of the vacuum pump.Installation requirements,　　 First of all, let&#;s understand the causes of insufficient liquid supply: If the liquid level stored in the circulating liquid storage tank is lower than %, then insufficient liquid supply will occur when it is in use. Or the pump adds too much lubricating oil, which leads to accumulation　　 It may also be because the pump&#;s liquid supply pipe is blocked by other substances during normal use.　　Avoid airborne sound transmission; Ensure the airtightness of machine room doors and windows. The water pump is equipped with a sound proof cover,ChakaritaBooster pipeline pump, and an exhaust fan is added inside the cover to ensure the ventilation of the equipment. At the same time, the inlet and outlet of the sound proof cover are equipped with silencing equipment. A vibration isolation platform is installed at the bottom of the water pump for foundation vibration reduction to isolate the vibration generated during the operation of the water pump

　　 The rotor assembly is designed according to the actual situation,　　In fact, the pumps I am going to talk about here have a wide range of uses. Pumps are required for both civil and military purposes, as well as for advanced technologies, especially in the mining, chemical, metallurgical and other industrial sectors. It is a widely used general mechanical equipment. Most pumps are corroded or severely corroded　　It is worth noting that the vertical pipeline pump can work like the self-priming pump after it is equipped with a siphon device. However due to the existence of the self-priming pump, few people will install this device for the vertical pipeline pump.　　 Another possibility is that the gas is sucked in when the pump is in use.Chakarita,　　For example,ChakaritaCorrosive pipeline pump, in the market, for example, the sweeping pump, some of which have a depth of more than meters, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.　　What is the solution to this situation?　　Yes, summer is the peak sales season. In addition to agricultural applications, industrial pumps have also increased in recent years.