To repair the equipment. Submersible slurry pump is a machine used to transport liquid. It can be divided into many types according to different transport media. Then, when transporting some media with special properties, the equipment will be treated with corrosion-resistant and wear-resistant process. Only in this way can the equipment be improved　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.Guadalajara, convenient operation, stable operation, easy maintenance, high efficiency, long service life, and strong self-priming capacity. There is no need to install the bottom valve in the pipeline. Before operation, it is only necessary to ensure that a certain amount of liquid is stored in the pump. Different liquids can　　There is a difference between submersible slurry pump and sewage pump. Although the media conveyed by the two are not pure water and other media, the difference between slag slurry and sewage is still large. Let&#;s take a look at the difference between the two.Table,　　The supply of shaft seal water must be ensured. It is strictly prohibited to operate without water otherwise the mechanical seal will be burned.　　The water pump is not only the water supply for the city,GuadalajaraQJ submersible pump, but also the household water purifier used in our home. There is a with pump equipment to help us purify water. In any way, it can be divided into many types, each of which has different sizes, volumes and s. Therefore,　　QW (WQ) submersible non blocking sewage pump needs to be equipped with a fully active water pump control cabinet under no exceptional conditions. Do not directly connect the power grid or use the knife switch to connect the power supply to ensure the normal operation of the electric pump.　　In this way, a smooth surface can be formed on the surface.Promise and keep promise,　　 selection of flow: single suction pump or double suction pump shall be selected according to the flow; single suction pump or multi suction pump shall be selected according to the lift.　　Balance of.　　In this way when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved, and the fact is

　　 The bus voltage where the motor is located is V. Due to the uneven cable voltage drop and load distribution, it is also possible that the temperature is too high due to the low voltage of the water pump.Customer first,　　If the shaft seal is not properly selected, but also leak a large amount of transmitted liquid.　　So as to meet the control of different fire water supply pumps by different users.　　There are many types of submersible slurry pumps available in the market, and different pump models have different performance and application fields. Therefore, although the pump has a wide range of applications, if its model is not correctly and reasonably selected,GuadalajaraDeep well pump, its application effect will be greatGuadalajara,　　 The submersible slurry pump needs to be inspected after reassembly. If the pulley needs to be rotated by hand, the pump shaft should not be blocked under normal conditions. In addition, the sound of collision between the impeller and the pump shell needs to be avoided.　　Therefore when the pump temperature is too high, you don&#;t need to panic. You can quickly troubleshoot according to the above-mentioned reasons,GuadalajaraSelf priming slurry pump wholesale, so as to find out the root cause of the excessive temperature of the equipment in time, and then take relative measures to effectively solve it.　　Some impurities will entangle the impeller, so generally, the open impeller will be used, so there is no need to worry about getting stuck in the process of transporting sewage.