All kinds of newly designed mechanical seals of submersible slurry pumps contribute greatly to the growth of market share.　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable, and the user needs to connect it separately during installation. If the connection is wrong, it will seriously affect the normal operation of the pump, so we should follow the correct steps to connect.Megikanos,　　Use a V megohmmeter to measure the insulation resistance between the electric pump motor and the phase to ground, and the value shall not be less than megohm. Otherwise,MegikanosWear resistant slurry pump, the stator winding of the motor shall be subject to monotonic treatment, and the monotonic treatment temperature shall not exceed ℃.　　Rate loss, so shaft power = effective power + lost power.Stowbtsy,　　 add water with manual pump. Some pump owners have their own hand pumps. They can also buy or manufacture their own small hand pumps. The gate valve shall be installed at the water inlet. After closing the valve, inject a small amount of water into the water compressor to divert water. When the hand pump discharges water, it means that the pump is full　　After the submersible slurry pump adds a water gun to the support at the bottom of the submersible slurry pump, the hardened mud layer around the slurry pump will collapse rapidly under the applied water pressure, which will also increase the sand pumping area. This will also increase the sand pumping area, so there will be no buried pump when it is used. However,MegikanosPipeline pump body,　　The development of submersible slurry pump is to adapt to increasingly complex working conditions, facilitate users to use, that is, in the traditional slurry pump

　　It is occasionally found that there is insufficient liquid supply when using, so what are the reasons for this situation and how to deal with it.　　 transmission device type (gearbox transmission flat belt transmission, V-belt transmission)　　Balance of.market,MegikanosWear resistant slurry pump,　　Cavitation of the pump is caused by water evaporation of the pump. The main cause of water evaporation is related to temperature and pressure. Under a certain pressure, when the temperature rises to a certain value, the water begins to vaporize and change from liquid to gas. On the contrary, the pressure drops to　　 The rotor assembly is designed according to the actual situation and the operation is more stable!　　The pump can often be selected according to the specific requirements of lift, flow and liquid delivery. The flow range of the delivered liquid is - L / s, the pressure range is .- MPa, and the diesel engine speed range is - rpm. Features: water pump, high automation and performance

　　 In addition, the use of ° and S-shaped bends should be reduced as much as possible during the installation and design of pipelines.Customer first,　　What is the order.　　The pipeline support is unstable and shakes.　　 First, screw down the bolts on the side bearing pressure cap, and then remove the nuts used for the connection between the three parts: discharge section, and successively install the bearing inner race, bearing gland and retaining sleeveMegikanos,　　 for screws that are too tight or rusted for a long time, the nut can be lubricated with kerosene prepared in advance, or the nut can be gently knocked with a wooden hammer and then removed. This method can also be used in slurry pumps and other places.　　Compared with the vertical slurry pump, the application market is also larger. In addition to the existing industrial and mining applications of the vertical slurry pump, the submersible slurry pump can also be used as a mobile slurry pump such as sand pumping on board, prospecting, etc; Submersible slurry pump assembly workshop III. what are the advantages of submersible slurry pump　　Normal operation. The submersible slurry pump can transport the slurry with corrosive or solid particles, coal slurry heavy medium transportation and dredging the river. When the equipment is pumping sand, some sand layers around the equipment will make the equipment covered by a large amount of sediment, and the current will slowly increase during use. Well, we should choose