WetlenInconel625 seamless pipe,

Alloy pipe is a spiral seam seamless steel pipe, which is made of hot-rolled strip steel coil, often processed by warm extrusion and welded by automatic double wire double side arc welding process. The alloy pipe sends the hot-rolled strip steel to the welded pipe unit, and the hot-rolled strip steel is extruded through multiple passes. The hot-rolled strip steel is rolled slowly to produce annular pipe material with open mouth gap. Adjust the reduction amount of the extrusion roll to control the welding gap at ~ mm and make both sides of the weld flush.Methods of exerting efficiency in application of C-section steelWetlen, Cleaning: first, clean the grease, dust and other substances attached to the surface of the galvanized pipe after cleaning. Remove defective pipes within the allowable length.Port Louis,Determined by the shape, the section modulus, moment of inertia and corresponding strength of I-beam are obviously better than those of ordinary I-beam with the same single weight. When used in metal structures with different requirements, pressure load and eccentric load. Compared with ordinary I-beam,WetlenQ345B longitudinal welded pipe factory, it can greatly improve the bearing capacity and save metal by % ~ %.I-beam is a kind of economical section steel with better section mechanical properties. Its characteristics are as follows:→ I-beam can be processed into T-beam, and honeycomb beam can be combined to form various section forms, which greatly meets the needs of engineering design and manufacturing.

H-shaped steel groove is deep and thick, and can withstand forces in two directions.They do not need to protect them from mechanical damage.Application scope of alloy pipeStandard requirements,Some applications of I-beam:It is often asked that the shape of I-beam is similar to that of H-beam. What is the difference between them? Many people can&#;t explain it in detail. Here is a detailed answer for you: many people think that I-beam is a domestic name and H-beam is a foreign name. In fact, this cognition is wrong. H-beam and I-beam are different in shape!When selecting I-beam in structural design, reasonable I-beam shall be selected according to its mechanical properties, chemical properties, weldability and structural size. I-beam is mainly divided into ordinary I-beam, light I-beam and wide flange I-beam. According to the height ratio of flange to web, medium and narrow flange I-beams.

Advantages of using I-beam: reduce maintenance cost reduce downtime, improve equipment operation rate, reduce wear, reduce equipment capacity and increase power consumptionquality indexGenerally, the process of pickling and passivation will be carried out for alloy pipes, but the alloy pipes after pickling and passivation are very easy to rust. Therefore, there is no harm to carry out hot galvanizing in the middle and later stage. Quality requirementsI-beam is divided into ordinary I-beam and light I-beam. The specification of hot rolled ordinary I-beam is -#. The specification of hot-rolled flexible I-beam supplied through agreement between the supplier and the buyer is -#. I-beam is mainly used in building structure, vehicle manufacturing, other industrial structures and fixed panels and cabinets. I-beam is often used together with I-beam.Wetlen,When we carry out different projects we must use different raw materials, which can ensure the quality of the project. In many kinds of data, alloy pipe is widely used. In many projects, we will apply it, so it is very popular in the field. When people carry out the construction of alloy pipe project, there are many things that must be paid special attention to. Let&#;s take you to know:H-beam is a widely used profile in steel structure buildings. It is different from I-beam. The first is the flange,WetlenGh2747 superalloy tube, and the second is that the inner surface of the flange has no inclination, and the upper and lower surfaces are parallel. The section characteristics of H-beam are obviously better than those of traditional I-beam, channel steel and angle steel.→ the two surfaces of the flange are parallel to each other, making it easy to connect, process and install.