Remove the flame. If the filler metal does not melt, continue to heat the joint and try again. The melted filler metal is sucked into the casing port according to the capillary effect until a complete filler metal ring appears on the casing port. Remove the flame Pay special attention not to let the flame directly contact the filler metal. It should be the heat at the joint that melts the filler metal. In order to clean the copper pipe, the welding flux must have a degree of corrosivity, and shall be cleaned after brazing. The so-called & quot; self-cleaning& quot; fluxes are generally not recommended because of their corrosivity.Advantages of red copper tube Durability: copper has stable chemical properties, integrating cold resistance,TrollhatanLow alloy plate, heat resistance, pressure resistance, corrosion resistance and fire resistance, and can be used in different environments for a long time.Trollhatan,The evaporated zinc is immediately turned into zinc in the air, forming white smoke, which brings great difficulties to the operation and affects the health of welders. Therefore, in the places where decorative brass pipes are welded, ventilation and other protective measures should be strengthened. The poor weldability of brass will cause problems such as pores, cracks, zinc evaporation and so on.Copper pipe has the characteristics of, and is the choice for the installation of water pipe, heat supply and refrigeration pipe.Mboursou Lere,Save materials and total cost, stability and performance, and can save maintenance.The room temperature tensile strength of the annealed red copper sheet is ~ kgf/mm, the elongation is ~%, and the Brinell hardness (HB) is ~The material of the water separator is the same, the expansion coefficient is the same, and the connection with the water separator is not easy to leak. Scope of application: As the copper pipe is more expensive than the plastic pipe, the cost of the floor heating system is higher.

Four of the five major application fields of copper plate, copper bar and copper pipe: copper is used as various pipes, pipe fittings and decorative devices in the construction industry.Advantages: low investment cost low production cost, high output and low price.Four of the five major application fields of copper plate, copper bar and copper pipe: copper is used as various pipes, pipe fittings and decorative devices in the construction industry.middleman,On the other hand, in the steel plant, the lock price of the steel plant has been falling all the time, and the order receiving is poor. The capacity utilization rate of the steel plant is low, but the market is still in oversupply. The stock of the steel plant and the spot stock are both risirising, so the market price has fallen sharply. Subsequently, the futures market rebounded in a wave, and the spot price also increased with the increase. There was an instant of large volume of transactions. However, with the decline of black futures, the market transaction volume shrank significantly. In addition, the inventory pressure was high, traders shipped at low prices, and the spot price fell under pressure. Due to the strong drop resistance of medium and thick plates, the drop amplitude and rate are less than those of threads.On the other hand, in the steel plant, the lock price of the steel plant has been falling all the time, and the order receiving is poor. The capacity utilization rate of the steel plant is low, but the market is still in oversupply. The stock of the steel plant and the spot stock are both risirising so the market price has fallen sharply. Subsequently, the futures market rebounded in a wave, and the spot price also increased with the increase. There was an instant of large volume of transactions. However, with the decline of black futures, the inventory pressure was high, traders shipped at low prices, and the spot price fell under pressure. Due to the strong drop resistance of medium and thick plates, the drop amplitude and rate are less than those of threads.Extrusion method: This production method is to cast copper ingots after smelting, and extrude copper tubes by large extruder after secondary heating.

On October ,TrollhatanAluminum plate, according to the Economic and Information Commission oong Province, at the end of September Shandong Province had resolved the overcapacity of million tons of pig iron and million tons of crude steel, and all the de capacity equipment had been shut down and withdrawn. On October , the Development and Reform Commission of Handan City released the Plan for Handan City to Eliminate Excess Iron and Steel Capacity. Statistics show that the iron making capacity of Handan in was million tons and the steel making capacity was million tons.Potential development, that is, the annealing process is added compared with the hard copper tube. Annealing of copper tubes means that they are calcined in a high temperature furnace to change the arrangement of the elements in the copper tubes. However, after annealing the copper tubes will become soft, which makes it easier to bend. The copper tubes produced in this way are called soft copper tubes.How to make copper tubes shine copper is stable in dry air, but the surface of power copper tubes is easy to be corroded in humid air, generating a layer of green material, commonly known as & quot; copper green& quot;, and its main component is & quot; basic copper carbonate& quot;. So, how to remove verdigris? We can remove the verdigris by mechanical friction, but this is not only troublesome, but also will damage the surface of the bronze. Here s a good way to remove verdigris. Use a measuring cylinder to measure ml of concentrated ammonia water and put it into a beaker, then add ml of distilled water, stir it with a glass rod to prepare ammonia solution, that is, wipe copper water. Copper rubbing water can react with verdigris to form soluble blue copper ammonia complex, thus removing the verdigris. In order to improve the effect of removing verdigris from the copper polishing water, chalk or talcum powder can also be mixed into the copper polishing water which can increase the mechanical friction, ensure the complete reaction of verdigris and ammonia, and make the copper surface smooth and bright. Dip cotton in copper water and repeatedly scrub copper products with copper rust. Soon, the copper rust disappeared from the surface of the bronze ware, while the cotton was dyed blue. When the verdigris on some copper products are not easy to remove, soak them in the copper scrubbing water for a while, and then scrub them with cotton dipped in the copper scrubbing water.In August, the price of domestic medium and heavy plates fell sharply. As of August , the price center of ordinary carbon boards in leading cities had dropped to , down yuan/ton from the end of July. At the beginning of the month, affected by the macro bad news, and the recent poor performance of fundamentals, the market mentality turned to pessimism, the inventory pressure was high, the stock shortage phenomenon disappeared, and the market transaction atmosphere was cold, the demand performance continued to decline, and the spot price fell under pressure.Trollhatan,Five of the five major application fields of copper plate, copper bar and copper tube: copper is used in medicine. In the s, Chinese medical inventors Liu Tongqing and Liu Tongle found that copper has extremely strong s and successfully developed the corresponding & quot; Cancer Suppressing & quot;, which is successful in the near future.In terms of steel billets: at :, some steel billets in Changli were reduced by , and the current carbon square billets were delivered with tax of yuan. After the th National Congress of the Communist of China, the market had doubts about the uncertainty of environmental production restriction and was still waiting for a clearer direction. Therefore, it can be seen that at this stage, there was no unilateral market for either futures or cash, and there was no definite pattern of ups and downs. According to the monitoring data of Lange Iron and Steel s cloud business platform, Tianjin Youwelded Line: the steel mill reported: Rongcheng # yuan/ton, B yuan/ton; Jiujiang # - # to Tianjin yuan/ton; The arrival price of Xinji Aosen # is yuan/ton, and that of B steel is yuan/ton; Jiyuan # yuan/ton,TrollhatanBronze plate, B steel yuan/ton; Fulen # yuan/ton; Weigang # yuan/ton, B steel yuan/ton.To sum up, due to the influence of factors such as the current spot market price is much higher than the expected winter storage price of merchants, the gradual emergence of supply and demand pressure, and the weakness of raw material support, among which the contraction of market demand has a greater impact. Therefore, the author believes that in the short term, the spot building materials do not have the possibility to rise significantly, and the price of building materials may mainly operate in shock, but with the shrinking demand, the supply and demand pressure becomes prominent However, it is still possible for merchants to lower the spot price in November.