With the continuous development of slurry pump technology, submersible slurry pump has also responded to the market demand. At the same time, this type of pump is especially suitable for the depth where the vertical slurry pump cannot operate. Pay attention when using the equipment. The submersible slurry pump can operate if its depth is less than m, but it exceeds　　Rate.Rosso,　　 Ensure that the electric pump operates normally The electric pump needs to be equipped with a fully active water pump control cabinet when there are no other conditions. Do not directly connect the power grid or use a knife switch to connect the power supply.　　Circumference. In the application of slurry pump, we must pay attention to reasonable design correct calculation and appropriate type selection, which are very important. In addition to the main wheel, a set of stirring impeller is added at the bottom of the product, which can spray the precipitated slag into a mixture of water and solid particlesKitale,　　Vertical slurry pump is an early product. Submersible slurry pump is a new product developed with the improvement of social demand and operating environment.　　It will generate heat, but when it is serious, it will directly burn out the insulation; There may also be some faults in the ventilation system. At this time, it is necessary to check whether the fan of the submersible slurry pump is damaged or rotating　　We also need to limit the starting frequency and select appropriate thermal protection devices for use.

　　The development of submersible slurry pump is to adapt to increasingly complex working conditions, and its use mode is more flexible. And it fills a part of the gap in the application of slurry pump. When the submergence depth is deep and there is no better slurry outlet, that is, there are other electric equipment on the user&#;s site, concentrate and tailings are treated in the concentrator, ash and slag are removed from the power plant, slime and dense medium coal are transported in the coal preparation plant,RossoWater well pipeline pump, and slurry is transported in coastal river mining operations. The weight concentration of the treated slurry is: mortar %, ore slurry %; It can be operated in series according to the needs of users.production costs,　　Submersible slurry pump is a kind of pump used in mines. Do you know the effect and form of its shaft seal? Let&#;s have a look.　　What is the cause of pump overload.　　The Tao part also consumes part of it.

　　What?Welcome to inquire,　　Submersible slurry pump it fills the gap in the application of slurry pump. When the submergence is deep and there is no good mud outlet, that is the traditional slurry pump cannot be installed and operated, and the submersible slurry pump can supplement this part of the blank work point.　　Fiber rope. Perform maintenance, replace new bearings and remove debris. In addition, the liquid may corrode the mechanical seal of the submersible pump or the pump body, causing water to enter the submersible pump motor and damaging the submersible pump motor. The effect of using sewage electric pump is good.　　What?Rosso,　　Reasonable.　　 Impeller protection in order to ensure the operation of the submersible slurry pump, it is necessary to timely adjust the clearance between the impeller and the front guard plate. When adjusting the impeller clearance, first stop the pump,RossoSubmersible slurry pump, loosen the bolts pressing the bearing box, loosen the adjusting nuts, make the bearing components move forward, and roll the shaft by hand to press the　　 A vent pipe is installed at the bottom of the pump,RossoLong shaft submerged slurry pump, so that when the pump is buried underground, water will be injected into the bottom of the slurry pump through the vent pipe, so that a sand water mixture will be formed at the bottom of the slurry pump so that the slurry pump can be started normally. The advantage of this approach is that even if