The application of pumps involves all aspects of work and production, and the types of pumps are also diverse. Some of the same pump have several names, and some of the names are very similar, which makes it difficult to distinguish. Today,MaryFire deep well pump, we will introduce the submersible pump and the submersible slurry pump. Is there any difference between the two　　Water flow into the bearing damages the bearing.Mary,　　Therefore it can be directly installed in the sewage tank without building a special pump room to install pumps and machines, which can save a lot of land and infrastructure costs.　　It will burn out. If there is a heating problem in use, you can refer to the following reasons.Cornwall,　　Promote the continuous expansion of the sales network group.　　What?　　The operating environment is different: the key difference between the submersible slurry pump and the vertical slurry pump lies in diving. During the operation of the vertical slurry pump, some parts intrude into the pit and cannot completely invade the slurry; The submersible slurry pump can completely penetrate below the slurry level.

　　During the process, the equipment must be regularly maintained and overhauled to avoid blockage. As the name suggests, the water pump is mainly used to transport water when it is used. The effect of normal pumps is often better when it is used, but in fact, we use it at ordinary times　　 use a volt megger to check the insulation resistance, which should not be less than . megohm. If it is lower than this value, open the drain hole and vent hole for drying or drying.　　When the equipment is in use, the water delivered in the pump receives the friction with the surface of the pump impeller,MaryQuotation slurry pump, so the pump needs to consume more energy to reduce the friction and resistance caused by the surface when it is rotating. Water will slowly overcome it as it flowsAnalysis project,MaryWQ submersible sewage pump,　　Where ρ—— Density of transmission medium liquid (kg/m; γ—— Gravity of medium liquid (n/m; H -- pump lift (m); Q - water pump flow (m/s); G - gravitational acceleration (m/s.　　The difference between the shaft power P and the effective power PE is the power loss in the pump which is measured by the pump efficiency. The pump efficiency is the ratio of the effective power and the shaft power, which is measured by η Indicates.　　It is not correct that it has no effect on us.　　 Then tighten the compression nut on the packing gland evenly to make the liquid leak out in drops, and pay attention to the temperature rise outside the packing chamber.

　　First, the submersible slurry pump is also a vertical slurry pump, because its axis is basically vertical when it works, but it can be completely immersed in water when it runs, so it is a good choicehow much,　　The effective power is also called output power, which is expressed by PE. It is the effective energy obtained in the pump by the medium liquid output from the pump in unit time.　　(a) The altitude shall not exceed m.　　Promote the continuous expansion of the sales network group.Mary,　　 important parts shall be marked in advance to avoid errors during resetting. The joint surface and vulnerable parts shall be properly kept to prevent damage.　　After the submersible slurry pump leaves the factory, there is generally only outgoing cable, and the user needs to connect it separately during installation. If the connection is wrong, it will seriously affect the normal operation of the pump, so we should follow the correct steps to connect.　　In recent years, submersible slurry pumps have replaced vertical slurry pumps. What are the differences between the two? Let&#;s yze.