NewmarkFast cold storageApplication of pneumatic test

2022-06-17 03:21:29
632HP195506591energy302

Floor insulation of medium-sized cold storage the structure of medium-sized cold storage is what we often call the surface, that is, the top and wall are made of color steel plate / stainless steel with appropriate thickness of polyurethane and other insulation materials, while the ground needs to be insulated separately. At present, the common operations in the market are: laying the ground with XPS extruded board, laying moisture-proof and steam isolating SPS materials above and below the extruded board respectively,NewmarkRefrigeration equipment for medical cold storage, and then pouring concrete or reinforced concrete.Polyurethane refrigeration board uses light polyurethane as the internal material of refrigeration board. The advantage of polyurethane is very good heat insulation. The exterior of the cold storage is composed of SII, PVC color steel plate and stainless steel plate. The advantage of this is that it can prevent refrigeration, because the temperature difference inside and outside the board is large, and the temperature will disperse, which makes refrigeration more energy-saving and improves the working efficiency of refrigeration.Newmark,Balance windows shall be provided for the fabricated controlled atmosphere storage.In fact, there are some unique installation skills when installing the cold storage? The cold storage installed according to these skills is often short in both effect and quality, and the specific installation skills of the cold storage will also make some relatively detailed introduction for you in the following article. When installing the cold storage, you should install it from the corner first. Later, according to the height of the cold storage, make a hole in the middle of the insulation board, and tighten the angle iron parts until there is a hole on the insulation boardArgenteuil,The combined cold storage does not cool or the cooling effect is poor. Check whether the condenser of the refrigerator is dirty. Whether frost is too thick on the evaporator in the warehouse. Check whether the refrigerant is leaking (apply soapy water to the pipeline connection, and if bubbles are generated, it indicates that the refrigerant is leaking). And ask the combined cold storage engineering personnel to supplement the refrigerant and deal with the leakage. Check whether the sealing of the combined cold storage door is intact and eliminate it. Whether the refrigerator of the combined cold storage works. Whether the parameter setting of the computer controller of the cold storage is correct, and reassemble the cold storage door for installation. Check whether the cooler in the cold storage fails and replace it. Whether there is enough clearance for stacking articles in the warehouse and dredge them.Where do you need to build the refrigerator, the size of the refrigerator or the storage capacity (size, storage capacity, ton, cubic meter, frame, box); What products are stored in the built cold storage? The actual storage temperature, storage time and setting temperature can be indicated by specific regulations; If your cold storage becomes larger, you need to master your individual storage volume the temperature of goods in and out of the warehouse, the frequency of opening and closing the door, etc. If this is clear, it is the selection of raw materials, such as refrigeration compressors, refrigeration units, industrial cooling fans / pipe slots, thermal insulation materials, coolers, temperatures and other refrigeration equipment.In the cold storage project, the selection of cold storage is related to the overall operation of cold storage in the future. The selection of high-quality cold storage is conducive to the use and maintenance of cold storage. This requires us to inquire more about the warehouse board for cold storage engineering. Before the construction of cold storage project, we should first realize the temperature requirements of cold storage and the importance of cold storage to cold storage. Because the cold storage project has high environmental requirements such as temperature, attention should be paid to the performance and material of the cold storage board when selecting the cold storage board.


NewmarkFast cold storageApplication of pneumatic test



These are several very common cold storage materials. The use of these materials has greatly improved the thermal insulation and refrigeration performance of the cold storage, which makes people's retained items more convenient and reliable. With the continuous development of material technology, today's various cold storage materials emerge in endlessly, we should make reasonable comparison and select products suitable for our own use needs and economic conditions.The circuit system must be -wire system. If there is no ground wire, the ground wire shall be added.Polystyrene foam: polystyrene foam is a new type of synthetic thermal insulation material. It is a kind of plastic, with small density, light weight, strong heat insulation effect and excellent low temperature resistance. However, due to its cold shrinkage, it is not very convenient for installation.Sampling inspection,The overall construction achievements of the cold storage project have been put into use, and the service life can reach years.When using the cold storage, try to keep the ground clean and professional cold storage installation,It is equipped with temperature compensation to automatically adjust the water temperature. The water temperature of ultrasonic atomization is - degrees. If our humidifier is connected with the warehouse, there is no temperature compensation, even in the work, the water temperature is low


NewmarkFast cold storageApplication of pneumatic test



Relative humidity maintenance of quick-frozen warehouse: humidification of quick-frozen warehouse is very important, from centrifugal humidification to high-pressure micro fog humidification, to the current ultrasonic humidifier. The utility model has the advantages of small particles,NewmarkFruit preservation cold storage, uniform humidification, no freezing and blocking, and no dirty blocking. The air conditioning humidifier we produce is specially designed for all kinds of vegetable and fruit quick freezing warehouses, which is essentially different from other humidifiers in the market: fully closed circulation, that is, take the gas in the warehouse, return to the warehouse through the humidifier and isolate it from the outside air.Design brand,The combined cold storage does not cool or the cooling effect is poor. Check whether the condenser of the refrigerator is dirty. Whether frost is too thick on the evaporator in the warehouse. Check whether the refrigerant is leaking (apply soapy water to the pipeline connection, and if bubbles are generated, it indicates that the refrigerant is leaking). And ask the combined cold storage engineering personnel to supplement the refrigerant and deal with the leakage. Check whether the sealing of the combined cold storage door is intact and eliminate it. Whether the refrigerator of the combined cold storage works. Whether the parameter setting of the computer controller of the cold storage is correct, and reassemble the cold storage door for installation. Check whether the cooler in the cold storage fails and replace it. Whether there is enough clearance for stacking articles in the warehouse and dredge them.When the actual scheme is determined, sometimes two defrosting schemes are adopted, and sometimes different schemes are combined. For example, the shelving wall and top smooth pipes of the controlled atmosphere storage can be manually combined with the hot gas method. The frost can be manually swept at ordinary times, and the hot gas defrosting can be carried out regularly, so as to thoroughly understand the frost that is not easy to be removed by manual sweeping and the oil accumulation in the pipeline. Cold fan water flushing and hot gas method. Hot air combined with water can be used for defrosting if there is a lot of frost and the controlled atmosphere storage needs to be defrosted frequently.These measures have achieved quite good results. Compared with several cold storages at a customer in Jining, the cold storages using their white materials have significantly lower power consumption than those using other white materials.Newmark,Other aspects: in the design process of food cold storage, it is also necessary to consider the cooperation between the cold storage and on-site fire fighting, water and electricity systems. It should meet the requirements of safety,NewmarkFruit cold storage, science and environmental protection. When designing and installing the cold storage, the drainage problem must be considered, and the following points should be paid attention to during redesign and installation.There are many kinds of cold storage. According to the material, it can be divided into color steel plate, stainless steel plate and salted steel. Among them, color steel plate has strong anti rust ability, but stainless steel plate has strong anti rust ability while salted steel has both beautiful appearance and anti rust ability. According to the layout, it is divided into flat plate and wave plate. The former is flat after the surface material is formed, and the latter is rugged after the surface material is formed. According to the thickness and color of surface materials, the thickness of stainless steel is .mm and mm, without color requirements; The thickness of salted steel plate is .mm, without color requirements; The thickness of PE paint baking board is .mm .mm ivory white, and the thickness of the vertical plate is mm and mm titanium white and white gray. The most important thing for the cold storage is the applicable temperature of the cold storage. It is divided according to the insulation thickness of the storage plate. The thickness of the sky floor of the mm storage plate is mm, which is suitable for the insulation conditions of - ℃ ~ - ℃; mm storage plate: the thickness of the ceiling plate is mm and the thickness of the vertical plate is mm, which is suitable for the thermal insulation conditions of ℃ ~ - ℃. The thickness of the ceiling plate and the vertical plate of mm storage plate is mm, which is suitable for the thermal insulation conditions above ℃. In fact there are many other classification methods of cold storage. Determined by the current processing technology, it can be divided into standard plate and non-standard plate according to the width and size range of warehouse plate, including standard plate vertical plate width wa = mm, heaven and earth plate width WB = mm, vertical angle plate W = mm, W = mm, WB and W.Polyurethane spraying is widely used in large and medium-sized refrigerators. Different well-known brands are produced at different prices, and the product quality is relatively large. However

404 Not Found

404 Not Found


nginx

Related articles

GeorgetownVegetable fresh storage companyService life impact of

GeorgetownVegetable fresh storage companyService life impact of

Cold storage construction: which one is suitable for you? Which one is suitable for you?In the proce...

FlourishingInstallation price of vegetable cold storageContent determination method

FlourishingInstallation price of vegetable cold storageContent determination method

The cooking materials and foods refrigerated in the quick-frozen warehouse contain a certain amount...

Vienna BadenCold storageDaily operation specification for maintenance of

Vienna BadenCold storageDaily operation specification for maintenance of

The refrigeration equipment in the fresh-keeping environment of the quick-frozen warehouse mostly ad...

Pak KobeChangzhi pharmaceutical cold storageThe right choice is particularly important

Pak KobeChangzhi pharmaceutical cold storageThe right choice is particularly important

small and medium-sized refrigerators are dominated by fully enclosed refrigeration compressors. Due...

DenverInstallation of large cold storageWhich company's price is better

DenverInstallation of large cold storageWhich company's price is better

Generally, in the actual operation of the refrigeration system, because the temperature conditions a...

SangrandCost of medical cold storageThe market has a strong upward atmosphere

SangrandCost of medical cold storageThe market has a strong upward atmosphere

In order to maintain a constant low temperature in the cold storage, attention should be paid to the...

评论列表

409HP184720764
2022-06-17 12:15:59

Since searching and shopping online, you never have to go out and wander around. Your NewmarkFast cold storage quality is guaranteed, logistics and delivery are fast, big brands are better than offline stores, and I will review them if necessary in the future!

570HP155642700
2022-06-17 10:51:26

Good seller, thank you. My colleagues like NewmarkFast cold storage very much. Come again next time!

263HP145816628
2022-06-17 11:41:49

It's worthy of praise, really good, NewmarkFast cold storage I like it very much.

122HP117294921
2022-06-17 12:07:58

I'm quite satisfied, and the quality and workmanship are even worse. Look back and introduce to friends

632HP195506591
2022-06-17 10:55:29

I think it’s pretty good. When I bought it, I saw the comments in the comments and I bought it. When I saw the shipment, I was very excited. After NewmarkFast cold storage arrived, I was excited and tried it with anticipation, and the result was pretty good! And the customer service lady is also very nice and polite. The customer service lady also answered my questions in seconds, haha, I will repurchase next time.

发表评论    

◎欢迎参与讨论,请在这里发表您的看法、交流您的观点。