The average service life of rigid polyurethane insulation structure with stable quality, long service life and high comprehensive cost performance can reach more than years under normal use and maintenance conditions. Under the normal service conditions during the service life of the structure, it will not be affected by drying or electrochemical corrosion, as well as the growth of insects, fungi or algae or rodents.Cold storage board, compressor, and other components in the cold storage can reasonably adjust the evaporation and condensation temperature, so as to improve the reduction of power consumption and reduce the production cost. Professional cold storage installation,CruyaFresh keeping cold storage installation manufacturer, installation of cold storage, cold storage construction, fruit preservation cold storage, medical cold storage, quality assurance, professional timely supply and high cost performance. It has become the preferred brand for many wire products. Welcome to buy! Save more resources.Cruya,The ground should be flat and not uneven. If the ground is uneven, the ground of the warehouse must be leveled before the cold storage can be built and installed.During the early operation of the refrigeration unit, carefully observe the oil return of the compressor and keep it clean. If it is found that the oil level is not clean enough or the oil level drops, replace it with new oil in time, so as to avoid bad compressor and reduce the service life of the compressor.Rach Gia,Fault phenomenon: high current or tripping during unit startup, and problems of user air switch; Input voltage is too low; The star angle conversion interval is too short (it should be ~ seconds); Hydraulic cylinder failure (no reset); Intake valve failure (too large opening or stuck); Loose wiring; Host failure; Main motor fault; TR time relay is broken (relay unit).During the cold storage commissioning, and timely deal with the problems of insulation and seal failure such as degumming and air leakage.Airtight construction of quick freezing storehouse: the modified atmosphere fresh-keeping storehouse is developed on the basis of the traditional high-temperature fresh-keeping storehouse, which has the & ldquo; Refrigeration & rdquo; Function long-term cold storage installation, cold storage installation, cold storage construction, fruit fresh-keeping cold storage, medical cold storage, complete products, excellent quality and favorable price. There are also & ldquo; Air conditioning & rdquo; Function; However, the quick freezing storehouse is not a simple superposition of ordinary high temperature storehouse and air conditioning equipment. In order to adjust the gas composition in the storehouse quickly, it is necessary to ensure that the quick freezing storehouse has good air tightness. This has been confirmed by the theoretical research and a large number of practical experience of quick freezing warehouse.

Other aspects: in the design process of food cold storage, it is also necessary to consider the cooperation between the cold storage and on-site fire fighting, ventilation, water and electricity systems. It should meet the requirements of safety, science and environmental protection. When designing and installing the cold storage, the drainage problem must be considered, and the following points should be paid attention to during redesign and installation.The controlled atmosphere warehouse is mainly used for the storage and processing of fruits. It can keep the low temperature of fruits in the cold warehouse and make the storage time longer. The walls of the cold warehouse are equipped with heat insulation panels, and the bottom is equipped with quick boards to prevent moisture and heat from the outside, Today, we'll take you to know some precautions about how to store fruits in the cold storage: disinfection treatment before fruits are put into the fruit preservation cold storage: the cold storage should be disinfected before fruits are put into the fruit preservation cold storage. Sulfur is used for disinfection. Generally, kg of sulfur can be used for disinfection of cubic meters, and then use sawdust to ignite and close the doors and windows. Don't open the doors and windows within two days. The storage volume of fruits should not be too large every time. It's good if the daily purchase volume is about %.Wall and floor fixtures shall start at corners. According to the plate layout drawing, transport the two plates at the corner of the required device to the device location. According to the plate beam height and the model of the angle iron for fixing the mushroom head nylon bolt, drill a hole at the corresponding elevation in the middle of the plate width. When drilling, the electric drill should be perpendicular to the plate surface. Put the mushroom head nylon bolt in the hole, tighten the angle iron, and tighten it horizontally, so as to make the nylon bolt on the surface of the warehouse plate slightly concave. When setting up the wall panels, foam data and other soft data should be laid on the floor slots along with the floor of the storehouse so as to avoid damaging the storehouse. After the two corner panels are neutrally removed from the floor, the plane position of the wallboard and the verticality of the storehouse should be adjusted in time according to the location of the laying line,CruyaHow much is the installation of small cold storage, and check whether the top elevation of the wallboard can be correct. After the position of the wallboard is correct, weld the angle iron on the plate beam and fix the inner and outer corners. When welding the angle iron parts,We should implement regular maintenance and daily maintenance professional cold storage installation, installation of cold storage, cold storage construction, fruit preservation cold storage, medical cold storage, large quantity, excellent quality and low price, strong and durable, safe and reliable, and maintain the operation rate of the compressor.Now let's analyze the production and use requirements of the cold storage. There is no condensation in the cold storage. Condensation in the cold storage or in the insulation layer is harmful. During the drying process of the new wall or under winter conditions, when the water vapor with high indoor temperature migrates outdoors, it is impossible to condense in the wall due to the obstruction of the cold storage.Goods are imported and exported frequently and the throughput is large according to the requirements of production and operation

Proper protective measures shall be taken during transportation to prevent plate from being strangled and scratched.resources,Cold storage, compressor overload, lack of refrigerant, excessive air intake, compressor jamming.After the installation of the controlled atmosphere storage,CruyaUndertake cold storage installation, another important finishing work is to purge the whole system. Compressed air will clean out the impurities remaining in the controlled atmosphere storage, which plays a key role in the use of the controlled atmosphere storage.General quick-frozen warehouses are mostly cooled by refrigeration mechanism with low gasification temperature (ammonia or Freon)Cruya,The importance of regular oil discharge, descaling and air discharge in the refrigeration system of the warehouse.It is required to set up a special tally room (area), and the temperature of the tally area is usually controlled at ~ + ℃.The average service life of rigid polyurethane insulation structure with stable quality, it will not be affected by drying, or electrochemical corrosion, as well as the growth of insects, fungi or algae or rodents.