SPC floor has several advantages: imitation of water, imitation of fire, formaldehyde anti oil stain, hospitals, schools, hotels, hotels, restaurants and other places.Polymer base material layer: a composite plate made of stone powder and thermoplastic polymer materials after stirring evenly and then extruded at high temperature. At the same time, it has the properties and characteristics of wood and plastics. Therefore, this floor has good strength and toughness. Ecological environmental protection;Welland,The surface layer of SPC floor has been solved by pur Crystal Shield, with good thermal insulation performance. It will not be cold even if barefoot steps on it. It is very comfortable. Coupled with the rebound technical layer, it has good flexibility.Even if you keep bending degrees, you don&#;t have to worry about falling pain. It is especially suitable for homes with elderly and children.SPC floor will be very astringent in case of water, that is, the sliding friction will increase, and the ground anti-skid performance will be very good.It also has high wear resistance.Even if the floor is rubbed back and forth with a steel wire brush, there will be no scratches, and the service life is more than years.Moreover, SPC floor is very light, with a net weight of only -kg per square meter, which is % of the raw materials of general floor. It can reasonably save the height width ratio of indoor space and reduce the bearing capacity of the floor.The SPC floor does not swell and deform, and does not need to be maintained in the middle and later stages. There is a sound insulation and noise reduction layer at the bottom, and the actual effect of sound insulation and noise reduction is also very good.There are many kinds of floors used in interior decoration. Community owners who have experience in interior decoration should know that different kinds of floors have different home decoration effects. Which kind of floor is better?Let&#;s take a look at the types of solid wood composite flooring.After - floors are assembled on the flat ground, observe whether the processing accuracy is flat and smooth, whether the tenon and groove bite is appropriate, not too loose or too tight by hand and eye observation.At the same time, carefully check the assembly height difference and gap between floors.Sandnes,Defects: poor wear resistance, no fire prevention, no corrosion resistance very easy to regain moisture, deformation, thermal deformation, folding, etc., which is difficult for medical treatment.SPC floor is an economical floor material. Consumers can enjoy the texture of wood grain or stone grain in use without being bothered by noise.According to the requirements of consumers for sound insulation, blocks plates or coils can be selected.Floor lacquer cloth, also known as floor leather (not PVC plastic floor), is a kind of paving material. It belongs to rubber plastic products. It is one of the indispensable floor materials for the decoration of power distribution room, substation and communication room. The thickness is -mm. Other thicknesses can be made according to the needs of users. The wear-resistant layer is generally less than or equal to .mm.The choice of lacquer cloth products shall be selected according to the suitability of the site.For example, the size of the product is determined according to the space of the house and the size of the place of use.At the same time, pay attention to the different places of use, and the selected patterns should also be different.For example, in places that need to be kept clean you can&#;t choose products with convex effect;In solemn places, it is not suitable to choose products with bright colors and messy.The width of coiled floor paint cloth is mm, mm and mm;The total thickness (referring to the base material, intermediate layer and surface wear-resistant layer) is divided into mm and mm;The length of each roll of floor leather is m and m.Other specifications and dimensions can be determined by the supplier and the buyer through negotiation.Because of the requirements of production, each roll of floor paint cloth is divided into several sections (the patterns between each two sections are misplaced), so the length of the small section of a roll of floor paint cloth with sections shall be indicated, and the length of the roll of floor paint cloth shall be increased by at least cm (i.e. not less than two complete patterns).Generally there can only be one section for high-quality products, and the number of sections of each volume of first-class products and qualified products shall not exceed ;The length of each section of first-class products shall not be less than m, and the length of each section of qualified products shall not be less than m.When inspecting the appearance quality of floor paint cloth leather, it should be visually inspected obliquely under the scattered sunlight or fluorescent lamp with the illuminance of ( ± LX and LM away from the tested sample.First, observe whether there are cracks, fractures and delaminations on the surface of the floor leather. If so, it can be determined that the floor leather is unqualified.The second step is to observe whether there are wrinkle marks, bubble pollution points and pattern deformation. What cannot be observed are excellent products and first-class products;If it is slight but not obvious, it is deemed as qualified. Go back to the third step to observe whether there are missing patterns on the surface of the floor leather and whether there are defects of the transparent wear-resistant film on the surface. If there is no, it is the first-class product and the first-class product. If there is slight missing or lack of film, it is the qualified product, otherwise it is the unqualified product.Finally, carefully check whether there is deviation during multi-color overprint on the surface, whether there are color differences in different parts, whether the superior products are uneven, and if there are the above two defects, the first-class products are those with but not obvious, and the products with obvious above defects but do not affect the overall beauty are determined as qualified products.Finally,WellandPark anticorrosive wood floor, based on the above judgment, the appearance quality of ground lacquer cloth is determined.The plastic coil floor paint cloth shall roll the wear-resistant layer outward on the pipe core and shall be externally packaged.The product name, manufacturer name, product mark, grade, batch number, quality and length shall be marked at the obvious place of each package.In addition to the above three items that can be directly judged by the senses, attention should also be paid to the physical properties when purchasing floor leather to ensure its service life. SPC floor adopts marble powder and new materials which is more green and environment-friendly.The cost of stone plastic floor is quite low, and it can be flame retardant. It has no affinity with water and is not easy to mildew. Stone plastic floor has sound-absorbing effect, so we don&#;t have to worry about the sound of high-heeled shoes hitting the ground anymore.

Sticker method: stick the same wood grain paper on the front and back of the board.First, slight scratches.Generally the plate has a certain degree of expansion, so some gaps (.mm is appropriate) should be left between the laths during splicing to avoid arching.If the floor of the room is uneven, it can be paved with wooden keel for leveling, and then nailed with lath on it. After planing, paint and wax can make the room elegant, extraordinary, clean and warm.A short wooden floor strip has been launched in the market, which can be combined freely according to the size of the room, and can be assembled into a variety of patterns at will.This kind of short plank is more practical, but the disadvantage is that the cost is not low.If the floor is made of wood, the wallboard can also be decorated with plates, so that the overall structure of the room tends to be unified.Wall panels can be used as whole wall paneling or only as dado paneling.Wood wallboard is the best for large wallboard concrete wall. It can directly fix the board to the wall with adhesive.If the white ash interior wall of brickwork structure is decorated with wallboard, it shall be fixed for minutes first×mm vertical wood wall reinforcement, and then fix the plate to the wood wall reinforcement with wood screws.Family decorative wallboard is best based on plywood, and its strength is appropriate.Then stick wood veneer on its surface to make up for the deficiency of plywood pattern.After the veneer is pasted, apply one or two layers of matte paint, and the pattern of the wallboard will be clear and beautiful, smooth and three-dimensional.Wood floor and wood wallboard interweave, making the style of the whole room unified, both simple and elegant.On the basis of uniform color or reasonable interweaving, it can make the whole room comfortable and soft, and give people an indescribable sense of mystery.Introduction of floor leatherproperty right,SPC floor is constantly favored by people at home and abroad. It is an all-round new favorite integrating the advantages of ceramic tiles and other types of floor materials. It is presented and interpreted with a variety of colors, environmentally friendly materials and diversified colors, making the noise and disturbance lose the sense of existence.Let&#;s take a look at the advantages of SPC floor after class.SPC floor is an economical floor material. Consumers can enjoy the texture of wood grain or stone grain in use without being bothered by noise.According to the requirements of consumers for sound insulation, blocks, plates or coils can be selected.Floor lacquer cloth, is a kind of paving material. It belongs to rubber plastic products. It is one of the indispensable floor materials for the decoration of power distribution room, substation and communication room. The thickness is -mm. Other thicknesses can be made according to the needs of users. The wear-resistant layer is generally less than or equal to .mm.The choice of lacquer cloth products shall be selected according to the suitability of the site.For example, pay attention to the different places of use, and the selected patterns should also be different.For example, in places that need to be kept clean, you can&#;t choose products with convex effect;In solemn places, it is not suitable to choose products with bright colors and messy.The width of coiled floor paint cloth is mm, mm and mm;The total thickness (referring to the base material, each roll of floor paint cloth is divided into several sections (the patterns between each two sections are misplaced), so the length of the small section of a roll of floor paint cloth with sections shall be indicated, there can only be one section for high-quality products, and the length of each section of qualified products shall not be less than m.When inspecting the appearance quality of floor paint cloth leather, it should be visually inspected obliquely under the scattered sunlight or fluorescent lamp with the illuminance of ( ± LX and LM away from the tested sample.First, observe whether there are cracks, fractures and delaminations on the surface of the floor leather. If so, it can be determined that the floor leather is unqualified.The second step is to observe whether there are wrinkle marks, bubble pollution points and pattern deformation. What cannot be observed are excellent products and first-class products;If it is slight but not obvious, it is deemed as qualified. Go back to the third step to observe whether there are missing patterns on the surface of the floor leather and whether there are defects of the transparent wear-resistant film on the surface. If there is no, it is the first-class product and the first-class product. If there is slight missing or lack of film it is the qualified product, otherwise it is the unqualified product.Finally, carefully check whether there is deviation during multi-color overprint on the surface, whether there are color differences in different parts, whether the superior products are uneven, and if there are the above two defects, the first-class products are those with but not obvious, and the products with obvious above defects but do not affect the overall beauty are determined as qualified products.Finally, the appearance quality of ground lacquer cloth is determined.The plastic coil floor paint cloth shall roll the wear-resistant layer outward on the pipe core and shall be externally packaged.The product name, manufacturer name,WellandWaterproof laminate flooring, product mark, grade, batch number, quality and length shall be marked at the obvious place of each package.In addition to the above three items that can be directly judged by the senses, attention should also be paid to the physical properties when purchasing floor leather to ensure its service life. After the floor has just been laid, always keep the indoor air circulating.

： I can smell faint wood fragrance. This floor shows that the glue content is very low.Up to European standard E level.target,Finally, which has produced a large sales market for reinforced flooring.The application of reinforced floor in home decoration can save a lot of cost budget.Precautions for solid wood floor installation : do not use the fixing method of wooden wedge and nail.Welland,The meaning of brand is by no means limited to the popularity of the enterprise.A mature and successful brand does not have strength and popularity, but forms a strong psychological connection with consumers.A recognized brand is established through the long-term interaction between enterprises,WellandReinforced composite floor, products and consumers. It is bred in the eyes of consumers by many factors, such as the accumulation of time, the practical action of enterprises, the continuous improvement of products and services and so on.Enterprise brand is a commitment and an attitude of an enterprise, which is a guarantee for consumers.Therefore when consumers choose products, they&#;d better choose big brands to get better guarantee of quality, service and so on. Anti slip, more astringent in case of water, not easy to fallNow there are many solid wood floor renovation boards on the market. The renovation boards are processed with solid wood floors as raw materials. They are recycled at low prices and sold at high prices, with considerable profits.How can we avoid buying refurbished boards?