In this way, when the equipment is used again, the solvent in the pump is often less, and the power consumption is also less, and the efficiency of the pump in use is often improved,　　Pumps, self-priming pumps, sewage pumps, chemical pumps and other pumps can also be called pipeline booster pumps.　　In addition to the method, materials shall be selected comprehensively according to the nature of corrosive medium, anti cavitation theory, corrosion mechanism of water pump and stress characteristics. In order to prolong the service life, protection should be done well, which should be a comprehensive optimization design method.Krasnodon,AlimaQuotation slurry pump,　　 install a valve to inject water at the water inlet and outlet. This method is to install a valve on the water inlet pipe of the submersible slurry pump and connect the water pipe to inject water into the pump. This is a common and simple method.　　 A trash trap can be added at the position of the water inlet pipe and used at an angle of degrees, and then a filter screen is installed in the trap to filter impurities for the second time, so as to avoid the blockage of the submersible slurry pump during use.　　 Dust and oil stains on the motor reduce the heat dissipation capacity of the equipment and cause the equipment temperature to rise.

　　 When stopping the operation of the submersible slurry pump, close the cock of the vacuum gauge and pressure gauge and the gate valve on the water outlet pipeline, and After that, cut off the power supply of the motor. If the temperature of the environment is low, open the square plug at the lower part of the pump body to remove the remaining water to avoid frost cracking. During operation the maximum temperature of the bearing shall not exceed ℃, and the quantity of calcium base grease used for lubricating oil bearing shall be the same as that of the bearing body　　In order to facilitate the disassembly of the impeller, the impeller is connected with the pump shaft through reverse buckle. This is why the impeller will be turned off when installing a new slurry pump. Therefore, we must pay attention to the impeller marked on the pump body during preliminary installation and use　　 Then replace the pulley and pump cover plate and tighten the fixing nuts.original,AlimaBaigang deep well pump,　　The utility and durability of the utility model, so the polymer composite materials are generally used in production.　　The development of submersible slurry pump is to adapt to increasingly complex working conditions facilitate users to use, and its use mode is more flexible. And it fills a part of the gap in the application of slurry pump. When the submergence depth is deep and there is no better slurry outlet, that is, in the traditional slurry pump　　The balance ring is also disassembled; Then remove the last stage impeller and the key back, and the middle section including the guide vane; in addition, remove the impellers, middle sections and guide vanes at other levels in the same way until the submerged slag slurry

　　It should be /-/ between. When the packing is worn, the packing gland can be properly pressed. If it is worn too much it should be replaced. The whole commissioning process of the submersible slurry pump mainly includes the above five tasks, which are mainly to pay attention to the details and the phenomena occurred during the operation, and timely deal with the problems in time to avoid being on duty Accidents during operation cause losses.Quality improvement,　　The direction of the differential pressure force is opposite, which can offset part of the axial force and prolong the service life of the bearing.　　Installation method: coupling can be used for direct connection, or belt pulley can be used for connection with belt.　　Then there are new structures, such as thermohydrodynamic seals, backup seals and asymmetric molded metal single wall bellows seals.Alima,　　Stability and reliability of seals between pump bodies.　　The high-efficiency slurry pump has three characteristics: first, the slurry pump has high operation efficiency and low loss.　　For example, in the market, for example,AlimaQJ submersible pump, the sweeping pump, it is not suitable to use a vertical slurry pump under such a working condition, but it is extremely easy to use a submersible slurry pump.